User`s manual

TLS PC Link

Programmer’s Guide

System Level Command Page

Set Printer to Inches (STX n) 19

Set Start of Print Offset (STX O) 19

Horizontal Alignment Offset (STX o) 20

Clear All Memory (STX Q) 20

Printhead Dot Pattern Test Label (STX T) 21

Send Binary Touch Cell Data (STX t) 22

Label Format Field Replacement (STX U) 24

Send ASCII Touch Cell Data (STX V) 25

Printer’s Firmware Version Information (STX v) 25

Request Memory Information (STX W) 25

Delete File (STX x) 26

Pack Memory (STX z) 26

Disable Feedback Characters (STX A)

This command disables the feedback ASCII characters.

Sample:

<STX>A

No feedback response

Enable Feedback Characters (STX a)

This command enables the feedback ASCII characters. These feedback

characters contain valuable information about system errors, printing completion,

and enabling of immediate commands. These characters are listed in Appendix

A. The printer is initialized with feedback characters turned off. When feedback

characters are enabled, all commands will have a response associated with them.

When there are no errors, the response will be ‘0’. There is no response to the

<STX> a command.

Sample:

<STX>a

No feedback response