User guide

Bradyprinter THT MVPplus Quick Reference Guide
Load the Media
English 13293LB-12 Rev. 2 16Nov2004 EN-5
Load the Media
This procedure is for loading media in Tear-Off Mode. For loading either fanfold media or roll
media with a printer option, refer to the User Guide.
1. See Figure 3. Press the printhead open lever.
The printhead assembly springs up. Continue to pivot the printhead until it locks into
place.
2. Slide out the media guide as far from the printer frame as possible.
3. Place the roll of media on the media supply spindle.
4. Load the media as shown.
For fanfold or roll media, refer to the User Guide.
5. Slide in the media guide so that it just touches, but does not restrict, the edge of the roll.
6. Close the printhead assembly.
Figure 3 • Load the Media
Media Supply
Spindle
Media Guide
Printhead
Open Lever
Printhead
Assembly