User guide

EN-16 13293LB-12 Rev. 2 16Nov2004 English
Bradyprinter THT MVPplus Quick Reference Guide
Maintenance
Figure 11 • Clean the Printer
Clean the Exterior
Clean the exterior of the printer with a lint-free cloth. Do not use harsh, abrasive cleaning
agents or solvents. If necessary, use a small amount of mild detergent or desktop cleaner.
Clean the Interior
Remove any accumulated dirt and lint from the interior of the printer using a soft bristle brush
or vacuum cleaner. Inspect this area after every four rolls of media.
Replace the Fuse
A user-replaceable AC power fuse is located just below the AC power switch at the rear of the
printer. The replacement fuse is a 3AG fast-blow style rated at 5 Amp/250 VAC. Before
replacing the fuse, turn the AC power switch off and unplug the AC power cable.
To replace the fuse, insert the tip of a flat-blade screwdriver into the slot in the end of the fuse
holder end cap. Slightly press in the end cap and turn the screwdriver counterclockwise. The
end cap disengages from the fuse holder and permits removal of the fuse.
To install a new fuse, reverse the sequence.
Printhead
Transmissive
Sensor
Reflective
Sensor
Take Label
Sensor
Ribbon
Sensor
Platen
Roller
Caution • No lubricating agents of any kind should be used on this printer! Some
lubricants will damage the finish and the mechanical parts inside the printer.