User guide

EN-12 13293LB-12 Rev. 2 16Nov2004 English

Bradyprinter THT MVPplus Quick Reference Guide

Configure the Printer

The configuration procedure in the next table contains the information you need to get your

printer up and running, but it is not comprehensive. Refer to the user guide for more

information.

To enter Configuration Mode, press SETUP/EXIT at the

PRINTER READY display.

Remember:

• Press SELECT once to use (+) and (–) to change the value of the selection.

• Press (+) to scroll to the next selection, increase the value, answer “yes,” or print a label

(when applicable).

• Press (–) to return to the previous selection, decrease the value, select the digit you wish to

change, or answer “no.”

• Press SELECT again to use (+) and (–) to scroll to the desired menu item.

Note • You will need to press (+) more than once to advance to some of the displays.

Table 4 • Configure the Printer

Menu Display Description

DARKNESS

0 to 30 (default setting is 10)

PRINT MODE

Tear-Off, Peel-Off, Cutter, Rewind (default setting is

Tear-Off)

MEDIA TYPE

Non-continuous, continuous (default setting is non-

continuous)

SENSOR TYPE

Web, mark (default setting is web)

SENSOR SELECT

Auto Select, Reflective, Transmissive (default is

Transmissive)

PRINT METHOD

Thermal transfer, direct thermal (default setting is thermal

transfer)

SAVE CHANGES

Permanent, temporary, cancel, load defaults, load last saved

(default setting is permanent)

PRINTER READY

You have exited Configuration Mode and are ready to print a

test label.