User guide

EN-8 13293LB-12 Rev. 2 16Nov2004 English

Bradyprinter THT MVPplus Quick Reference Guide

Position the Reflective Sensor

Refer to Figure 6.

1. Open the printhead assembly and turn on the AC power.

2. Locate the reflective sensor positioning lever.

3. For non-continuous media: Move the lever across the width of the media to align the

reflective sensor with the start-of-label indicator (notch, hole, black mark, or gap). The

glow of the red LED through the media helps to position the sensor.

4. For continuous media: Position the reflective sensor anywhere under the media so that a

“MEDIA OUT” condition can be sensed.

5. Ensure that the media and ribbon are properly positioned.

6. Close the printhead assembly.

Figure 6 • Position the Reflective Sensor

Note • This sensor is typically covered by a factory-installed plate. If you need to enable this

sensor, you must remove the plate.

Printhead

Transmissive

Sensor

Reflective

Sensor

Reflective Sensor

Positioning Lever