Specifications
3-30 Label Design
7KH%DU&RGH$WWULEXWHVZLQGRZGLVSOD\V
2) Press the ↑ or ↓ key to move the cursor to the option you want to set.
3) When the option you want to set is highlighted, press the
← or → key to scroll
through the available settings. (Refer to the table below.)
4) When the settings you want to use are displayed, press Enter.
Bar code option What it does
Symbology Sets the bar code symbology. The available symbologies are Code
39, Code 128A, Code 128B, Code 128C and Interleaved 2 of 5.
Height Determines the bar code height. Enter values from 0.25 to 8.5
inches (default is 1.0) or from 6 to 215 mm. The unit of measure is
the Length units setting. (Refer to “Setting system defaults” on page
1-23.) This height does not include the human-readable text.
Density Controls the width of the bar code’s narrow elements. This setting
determines the width of the quiet zone (the clear space that
precedes the bar code’s start character and follows the stop
character). The quiet zone width is ten times the density value you
select. Choose 10, 20, 40, 50, 60, 80 or 100 mils.
Human readable text Specifies whether or not human-readable text is printed with the bar
code. Choose Below (default) or None.
Start/Stop in HR text Determines whether or not the start and stop characters are printed
in the human-readable text. Choose Off (default) or On.
Check character Controls whether or not a check character is printed for the bar
code. Choose Off (default) or On.
Human readable text size Sets the size of the human-readable text. You can select a type
size from the available settings. You can also select the Auto
setting, which scales the text to 25 percent of the bar code height. If
the Human readable text option is set to None, this setting is
ignored. The unit of measure is the Type size units setting. (See
“Setting system defaults” on page 1-23.)
Symbology: Code 39
Height (1.0 - 8.5 inches): 3.50
Density: 20 mil
Human readable text: Below
Bar Code Attributes
Press ↑↓←→, ENTER or ESC