Specifications

Using standard layouts 2-13
To select label options for a specific area in a standard layout:
1) Place the cursor in the standard layout area in which you want to make a change.
Press the Label Options key.
7KH/DEHO2SWLRQVZLQGRZGLVSOD\V
2) Press the ↑ or ↓ key to move the cursor to the option you want to change.
3) When the option you want to set is highlighted, press the
← or → key to scroll
through the available option settings.
4) Repeat these steps if you want to choose settings for other label options.
5) Press Enter when all of the settings you want to use are displayed.
7KH0DNH&KDQJHZLQGRZGLVSOD\V3UHVVWKH↑RU↓NH\WRKLJKOLJKWWKHRSWLRQ
\RXZDQWWRXVHVHHWKHWDEOHEHORZ7KHQSUHVVWKH(QWHUNH\
Label option What to do
Justification Choose Left, Center or Right. The default justification value is set
through the Setup options as described in “Setting system defaults”
on page 1-23.
Text position Choose Top, Middle (default) or Bottom to control whether the text is
vertically centered in the top third, middle third or bottom third of the
label.
Text direction Choose Along tape (default), Up tape or Down tape.
Line spacing Choose Normal (default), Tight or Loose. The Loose setting may
provide better results when printing accented characters.
Baseline Choose Center (default) or Fixed.
Make Change option What it does
At beginning of text Changes the option for all text in the text buffer.
At beginning of area Changes the option for all text starting with the current area.
Justification: Center
Text position: Middle
Text direction: Along tape
Line spacing: Normal
Label Options
Press ↑↓←→, ENTER or ESC
At beginning of text
At beginning of area
Make Change
Press ↑↓, ENTER or ESCAPE