Specifications

1-26 System Basics
Checking system status
8VHWKH6WDWXVNH\WRFKHFNFHUWDLQVXSSO\DQGV\VWHPLQIRUPDWLRQ7KHVHYDOXHVDUH
GLVSOD\HGKHUHIRULQIRUPDWLRQRQO\DQGFDQQRWEHFKDQJHGLQWKLVZLQGRZ
1) Press the Status key.
7KH6WDWXVZLQGRZGLVSOD\V
2) Press the ↑ or ↓ key to move through the options listed below and view their
current settings.
3) Press Enter to close the Status window.
Status option What it does
Tape color Indicates the color of the installed tape.
Tape width Indicates the width of the installed tape. The unit of measure is the
Length units setting selected in the Setup window. (Refer to “Setting
system defaults” on page 1-23.)
Tape remaining Indicates the amount of tape remaining on the installed supply. The
unit of measure is the Length units setting selected in the Setup
window. (Refer to “Setting system defaults” on page 1-23.)
Tape type Indicates the type of tape that is installed (continuous or die-cut).
Ribbon color (1-4) Indicates the color of the installed ribbon. Paneled ribbon colors are
listed in order. For monochrome ribbons, one color is listed and the
remaining values are None.
Ribbon width Indicates the width of the installed ribbon supply. The unit of
measure is the Length units setting selected in the Setup window.
(Refer to “Setting system defaults” on page 1-23.)
OS version Indicates the current operating system version number.
Hardware version Identifies the current circuit board revision ID number.
2 - indicates the original PowerMark memory configuration: 2M RAM
3 - indicates the enhanced memory configuration: 4M RAM
This setting affects the maximum length you can designate for a
label, which in turn affects other label options. See “Setting label
length” on page 3-12 for more information.
Status
Press ↑↓, ENTER or ESCAPE
Tape color: White
Tape width: 10 in
Tape remaining: 50 ft
Tape type: Continuous