Service manual
7
Printer Applicator System PAM 3600
Service Manual PAM 3600 1 Introduction
1.4 Safe Handling of Electricity
Follow the additional instructions below when handling electricity:
Find out the positions of the emergency and the power switch in order to operate them quickly in an emergency
situation!
Do not work alone under dangerous working conditions or while working on devices with non-protected
voltages (over 50 V AC or 120 V DC)!
Turn off power to the printer before:
removing or installing power units,
working in the immediate vicinity of open power supply parts,
mechanical checkup of power supply parts,
changing circuit boards or electrical parts.
If you cannot avoid working on devices with non-protected voltages, follow these safety precautions:
Have a person nearby who is aware of the position and operation of the power switches, who will switch off
the power in case of danger.
Use only tools and test devices, which are suitable for the work being done.
Work only with one hand on devices that are switched on. Keep the other hand behind your back or in your
pocket until you have nished.
NOTICE!
A shock occurs only with a closed circuit. By using only one hand, as described above, you
would avoid a current ow through your own body.
Do not use worn or defective tools!
Never assume that a circuit is not powered. Always verify that there is no voltage present!
Always examine the work area for possible sources of danger, such as wet oors, defective extension cords,
faulty protective grounding connectors etc.
If you observe an accident with electricity:
Be careful and avoid danger to yourself.
Switch off power.
Request medical assistance.
Give rst aid if necessary.
1.5 Printer Types
There are two printers for the PAM 3600 systems available:
PAM 3630 with a printhead resolution of 300 dpi and
PAM 3660 with a printhead resolution of 600 dpi.
Both printers can be equipped with one of the applicator types
PAM 3602, tamp-blow applicator with vertical lift (main) cylinder and turn cylinder and
PAM 3603, tamp-blow applicator with vertical lift (main) cylinder and horizontal lift cylinder.
•
•
•
-
-
-
-
•
-
-
-
•
•
•
•
-
-
-
-
•
•
•
•