Service manual

59Printer Applicator System PAM 3600
Service Manual PAM 3600 5 Adjustments
Setting the Speed of the Turn/Lift Cylinder Movement
The speed of the turn cylinder (PAM 3602) respective the lift cylinder (PAM 3603) movement also can be set via two
valves.
LIFT
CYL.
VACUUM
BLOW-
AIR
BRAKE
TABLE
SUPPORT
AIR
PRINT
HEAD
ROTATE
CYL.
1 2 3
6 54 5
Figure 5o Setting the speed of the turn/lift cylinder movement
1 Valve key turn/lift cylinder
2 Valve for movement from the dispense edge
3 Valve for movement to the dispense edge
4 Pad PAM 3603
5 Dispense edge
6 Pad PAM 3602
Remove the cover.
Turn one of the valves (2, 3) to regulate the speed.
Turning clockwise will close the valves.
A wider opening of the top valve (2) speeds up the pad (4, 6) moving from the dispense edge (5) of the
printer.
A wider opening of the bottom valve (3) speeds up the pad (4, 6) moving to the dispense edge (5) of the
printer.
3. Check the speed by releasing a movement of the turn/lift cylinder. For that purpose press the integrated key (1)
on the concerning valve.
4. If the setting is correct mount the cover.
5. Check the time for the turning movement.
1.
2.
-
-