Service manual

50 Printer Applicator System PAM 3600
Service Manual PAM 36005 Adjustments
5.3 Adjusting the Guide Plate
It is possible that the guide plate (2) becomes loose by the movement during the operating process. For that reason
it is necessary to readjust the guide plate to guarantee a proper print image.
WARNING!
Mortal danger by electric shock!
Disconnect power supply!
Switch off compressed air!
1 21 4 133 5
Figure 5c Adjusting the guide plate
1 Guide wheel
2 Guide plate
3 Guide wheel
4 Bushing
5 Nut
Remove the cover.
Check the clearance of the guide plate (2) by moving the four guide wheels (1, 3) on both sides of the plate
manually.
When the clearance is too large it is possible to move the wheels lightly.
Loosen the nuts (5) of the two guide wheels (1) on the left side.
Tighten the two guide wheels (1) by screwing the respective hexagon adapter bushing (4) to readjust the guide
plate. These wheels are mounted eccentrically.
Tighten the two nuts (5).
Mount the cover.
1.
2.
3.
4.
5.
6.