Service manual

44 Printer Applicator System PAM 3600

Service Manual PAM 36004 Replacing Assembly Units

Sensors printhead cylinder

19 19

Figure 4u Replacing the printhead cylinder sensors

19 Printhead cylinder sensor

Remove the cover.

Loosen the screw on the concerning sensor (19).

Remove the cable from the cable holder (g. 4q, 2).

Remove the plug (g. 4q, 5) from the applicator control PCB (g. 4q, 3), loosen the screws of the concerning

cable and remove it.

Replace the sensor and reassemble in reverse order.

Connect the printer to the power supply, switch on printer and compressed air.

Check the replaced sensor of correct adjusting and adjust if necessary (see section 5.5).