Service manual

43Printer Applicator System PAM 3600

Service Manual PAM 3600 4 Replacing Assembly Units

Sensor transport locking roller

13 14

Figure 4s Preparation

13 Head plate

14 5 screws

Remove label stock and transfer ribbon from the printer.

Remove the cover.

Pull out the concerning plug (g. 4q, 7) on the CPU PCB (g. 4q, 6).

Loosen the ve screws (14) and remove the head plate (13).

Move the whole mounting forward.

View A

15 1516 17 18

Figure 4t Replacing the sensor transport locking roller

15 Screw

16 Bracket

17 Screw

18 Sensor transport locking roller

6. Loosen the two screws (15) on the bracket (16).

7. Take out the bracket with the mounted sensor.

8. Loosen the two screws (17) holding the sensor (18).

9. Replace the sensor and reassemble in reverse order.

10. Connect the printer to the power supply, switch on printer and compressed air.