Service manual

36 Printer Applicator System PAM 3600

Service Manual PAM 36004 Replacing Assembly Units

4.8 Replacing the Main Drive Motor

WARNING!

Mortal danger by electric shock!

Disconnect power supply!

Switch off compressed air!

Ribbon

G-TESTED

05/N31

MOTORHEADLOCKPERIPERIPANEL

PRINTHEAD

POMER SUPPLY

GAP SENSOR

IEEE1284

USB MASTER SERIAL

1 2

3 4 5 6

Figure 4l Replacing the main drive motor

1 CPU PCB

2 Plug

3 Gear

4 Belt

5 4 screws

6 Main drive motor

Remove the cover at the rear side.

Loosen the belt (4) by taking off it from the gear (3).

Pull out the plug (2) of the motor from the CPU PCB.

Remove the four screws (5) of the motor (6).

Replace the main drive motor (6).

Fasten the motor by tightening the four screws (5).

Put the plug (2) of the new motor into the socket of the PCB.

Tighten the belt (4) by putting it on the gear (3).

Mount the cover at the rear side.