Service manual

32 Printer Applicator System PAM 3600

Service Manual PAM 36004 Replacing Assembly Units

4.6 Replacing the Label Edge Sensor

WARNING!

Mortal danger by electric shock!

Disconnect power supply!

Switch off compressed air!

43221

Figure 4f Replacing the label edge sensor

1 Cable

2 Label edge sensor

3 Hole

4 Screw

Remove label stock and transfer ribbon from the printer.

Remove the cover at the rear side.

Pull out the cable (1) from the label edge sensor (2).

Remove the screw (4).

Remove the label edge sensor (2) by pushing it through the mounting plate to the rear side.

Push the new label edge sensor through the mounting plate.

Put the screw (4) through the sensor into the hole (3) of the plate and tighten it.

Reassemble the other parts in reverse order.

NOTICE!

Make sure that the cable does not touch or hinder moving parts.

9. Adjust the label edge sensor (see section 2.4).