Service manual

30 Printer Applicator System PAM 3600
Service Manual PAM 36004 Replacing Assembly Units
4.5 Replacing the Pinch Roller
WARNING!
Mortal danger by electric shock!
Disconnect power supply!
Switch off compressed air!
1 2 3 4
5 6 7
Figure 4d Preparation
1 Gear
2 Belt
3 4 screws
4 Main motor
5 Belt
6 Pulley
7 Snap ring
Remove label stock and transfer ribbon from the printer.
Unlock the transport locking roller by pressing down the knurled knob (10).
Remove the cover at the rear side.
Loosen the belt (2) by taking off it from the gear (1).
Remove the four screws (3) at the main drive motor and take off the motor (4).
Remove the belt (5) from the pulley (6).
Remove the snap ring (7) from the axle of the pinch roller and take off the pulley (6).
1.
2.
3.
4.
5.
6.
7.