Service manual

20 Printer Applicator System PAM 3600
Service Manual PAM 36002 Expanded Functions for Servicing
Adjusting the Label Edge Sensor
The function "Adjust gap sensor" enables the label edge sensor to be adjusted. This is necessary when the label
edge sensor itself or the CPU PCB are replaced.
NOTICE!
In order to avoid the inuence of light from the outside, check the adjustment of the sensor with
the cover closed and housing mounted!
Perform the adjustment as follows:
Insert the service key into the Master USB socket.
Select the "Service" menu in the ofine menu and conrm with the key.
Select the "Adjust gap sensor" function in the "Service" menu and conrm with the key.
Open the printhead.
The request "Please remove label stock" from label edge sensor appears in the display. Obey the request,
close the printhead and conrm with the key.
The display now requests "Please insert liner" into the label edge sensor.
Insert the liner material (without labels) into the label edge sensor, lock the printhead and conrm with the
key.
NOTICE!
Ensure that there are not any labels on the liner in the vicinity of the label edge sensor. This
would lead to a faulty alignment and a device malfunction.
7. "OK" appears in the display when the adjustment has been successful. Press the key again. The adjustment
has been completed now.
The message "Error" appears in the display if a fault occurs during the adjustment. If a fault recurs when the
adjustment is repeated, then there could be a defect in the following components:
Label edge sensor,
Label edge sensor connection cable or
CPU PCB.
Saving the NVRAM
The "Save NVRAM" function is used to save a printer conguration on a CompactFlash memory module.
This function is only accessible with the service key inserted and the CF card in the slot.
Save on the NVRAM as follows:
The printer is switched on.
Insert a CF card into the CF slot.
Insert the service key into the Master USB socket.
Select the "Save NVRAM" function in the "Service" menu and press the key.
"No" appears in the display.
Change the selection to "Yes" with or and press the key. The saving begins and is indicated by the
green LED next to the CF slot.
CAUTION!
Data loss!
Do not press the ejection key for the CF card while the green LED is lit.
If an error message appears in the display, this may indicate an unreadable CF card (e.g. unknown card type,
unformated card).
NOTICE!
To format the CompactFlash memory module, please refer to the "Memory Modules" section of
the Operator's Manual.
1.
2.
3.
4.
5.
6.
•
•
•
1.
2.
3.
4.