Service manual

Printer Applicator System PAM 3600

Service Manual PAM 3600 2 Expanded Functions for Servicing

Device List

The most important hardware components installed in the printer and the connected optional devices are listed in

the "Device list" submenu.

Please also refer to the "Test Functions" section of the Operator's Manual for the printout of the device list and

further information.

Proceed as follows to print the device list:

Insert the service key into the Master USB socket.

Switch from online mode to the ofine menu by pressing the key.

Press the or key until you reach the "Test" menu, and then press the key.

Select the "Device list" function with the or key and conrm with the key.

Start the printout with the pre-dispense key.

The printout can be aborted with the key.

The printout contains the following information:

CPU Type and serial number of the CPU PCB, revision number of the CPU PCB and FPGA

TPH Resolution and number of hot points of the thermal printhead

CARD* Capacity, manufacturer, serial number and version number of the FlashCard

SLOT* Type, serial number and revision number of the interfaces expansion card

USB [a]* Type and revision number of the installed

[b/c] s USB devices

a: Number of the USB device

b: Number of the USB device to which device a is connected

c: Port number of device b, to which device a is connected

s: Speed of the USB device (Low Speed or Full Speed)

Only with inserted service key:

Mfr. Manufacturer ID indicates the manufacturer of the USB device

Class Code number for the USB device class

Protocol Code number for the type of communication with the USB device

Phase Internal value for debugging purposes

(* This information is only printed if the corresponding devices are installed.)

Figure 2c Device List with Service Key inserted