User`s manual

NetDoc™ User’s Manual 1-121 Rev B
Setting Up the Cabling Infrastructure
Adding Tubes in Pathways
Tubes are usually used with airblown fiber cables. You must set the pathway source and
destination before you can add or connect tubes. The source and destination pathways can be
set from the Info tab.
To add tubes:
1. On the Navigation Tree, locate the space where you want to add a pathway tube. The
Source and Destination information will display on the Info tab.
2. On the Info tab, enter the number of tubes you want to add for this pathway.
Note: There are no limits to the number of tubes that can be added.
3. Click the Tubes tab.
4. If desired, enter a new Tube ID for each of the tubes you are adding.
5. From the Connected Tube Source list, select one of the unconnected source tubes.
Note: All unconnected tubes are listed for both the Source and Destination you have
selected. For example, if you choose Floor 1, all unconnected source and destination tubes
for Floor 1 will be listed.
6. From the Connected Tube Destination list, select one of the unconnected destination
tubes.
7. To connect all unconnected tubes for this location and pathway, in sequence, select the
tube source or destination and click .