User`s manual

NetDoc™ User’s Manual 1-113 Rev B
Setting Up the Cabling Infrastructure
Identifying Backbone Pathways Used
The Pathways Used tab identifies the pathways in which the backbone is located. When
adding pathways, add them in order from Source to Destination.
To add pathways used:
1. Click the Pathways Used tab.
2. In the Detail area, click Add.
3. In the Location window, select the first Pathway this backbone is in, then click Accept.
The Segment, Pathway ID, Pathway Type, and Source are populated on the table.
4. Click Save.
Note: The Segment column identifies the order in which the backbone uses each of the
pathways.
Connecting a Backbone to a Grounding Conductor
If a Grounding Conductor has been set up in the Grounding tab and connected to the current
backbone, the Bonding Conductor ID field will be populated in the Backbone Info tab. See
“Grounding” on page 1-114.