User`s manual

NetDoc™ User’s Manual 1-107 Rev B
Setting Up the Cabling Infrastructure
Setting Backbone Source and Destination
To set the backbone source:
1. On the Navigation Tree, highlight the Space where the backbone cable is located.
2. In the List View pane drop-down list, choose Backbone Cables.
3. Click the Source tab. The Connection Location box is populated with the selected source
location.
4. In the Connection Device Type box, click the appropriate radio button:
• Termination Hardware: If this backbone starts on termination hardware.
•
Splice Enclosure: If the backbone starts at a splice.
•
Asset : If the backbone starts at an asset.
5. Click Save.
To set the backbone destination:
Note: The Destination tab function is similar to the Source tab, except that the Connection
Location Select information is not populated.
1. On the Navigation Tree, highlight the space where the backbone cable is located.
2. In the List View pane drop-down list, choose Backbone Cables.
3. Click the Destination tab.
4. In the Connection Location window, click Set Location.
5. From the Navigation Tree, choose the Destination. The Building, Floor, and Space are
automatically populated, unless you are connecting from an outdoor space (e.g., a Utility
Pole), in which case, only Space is populated.
6. Click Accept.