User`s manual

1-104 Rev B NetDoc™ User’s Manual
Setting Up the Cabling Infrastructure
Adding User-defined Splice Types
To add user-defined splices to the closure:
1. In the List View pane drop-down list, choose Splices.
2. In the Spreadsheet area, click Add.
3. In the Splice ID column, enter the splice ID.
4. In the Type column, enter the splice Type, or select an existing type from the drop-down
list.
5. In the following columns, enter the appropriate information:
• Equipment: Enter a new equipment, or select existing equipment from the drop-down list.
•
Manufacturer: Enter a manufacturer, or select an existing manufacturer from the drop-
down list.
•
# of Pairs: Enter the maximum number of cable pairs that this splice can contain.
6. When done, click Save.
Connecting a Backbone Cable to a Splice
Connecting a backbone cable to a splice must be done from the Backbone area (see
“Backbone Cables” on page 1-105).
Once you have spliced a backbone cable, you can view all backbones connected to a splice in
the Connected Backbones tab from the Detail View of a splice.