User guide

LOCKOUT-PRO

ENTERPRISE User Guide 7-

Accessing System Defaults

If you have Admin-level permissions, you can change any of the system defaults in the

LOCKOUT-PRO

application — whether for all user groups, or only some — via the Admin option

on the Main Menu. You must be working online to change defaults.

To access the system defaults:

1. From the Main Menu, click Admin.

2. From the submenu, select either:

•

All Groups

: To change defaults for all user groups enterprise-wide.

•

Specific group

: Choose from the names on the list (a checkmark will display by the group you

select.)

Note: Until you make a selection, the Set Defaults option on the Admin menu is greyed-

out and not available.

3. From the Admin menu, click Set Defaults. The Set Defaults window opens displaying 5 tabs —

one for each category of defaults.

4. Click the category tab for the settings you want to change.

5. Follow the specific steps listed below for working with each type of default:

• Energy source defaults

• Basic data defaults

• Lockout step defaults

• Procedure defaults

• Section settings defaults

6. When you are done working with the defaults, on the Set Defaults window, click OK to return to the

main window.

Tip!

When changing a default, be sure to verify that your changes are correct before clicking

OK. If you make an error or change your mind, you can restore the existing defaults by

clicking Cancel on the Set Defaults window. The window will close, and your changes

will be discarded.