User guide

LOCKOUT-PRO
TM
ENTERPRISE User Guide 5- 29
Using Labels on Images
LOCKOUT-PRO
TM
Graphical Procedure Writing Software lets you add energy source labels or text
labels to the images in your procedures. You can use labels to pinpoint the control points or to direct
attention to another part of the photo.
To add labels to an image:
1. After adding the image to the procedure (see Adding Images to Procedures on page 5-27),
access the image in the Edit Image window.
2. To open the Label Image window, click Label Image....
3. To add an energy source label (e.g., E-1, H-1):
a. Select the energy source from the list of sources in the box to the right of the image.
b. Click < Add to Image. The energy source abbreviation displays in a box in the upper left
corner of the image.
c. Repeat this step to add other energy sources from the list.
4. In the Custom Text box, enter any text you want to display in a label on the image and
click < Add to Image.
5. To move each label to its appropriate location on the image, click on the label and drag it to the
correct place on the image.
6. To remove a label you added, click on the label where it displays on the image, then click
Remove Label.
7. When you are done adding and placing labels, click OK.