Brady Worldwide Identification Solutions 6555 West Good Hope Road P.O. Box 2131 Milwaukee, WI 53201-2131 Phone: (800) 537-8791 Fax: (800) 292-2289 www.bradyid.
CONTENTS 22-POWER CORD NOTE: Drawing not to scale – for reference only. 19A-Base/Main Plate screw(2ea) 19-BASE 20A-Relay/Base screw(2ea) 20B-Nut(2ea) 20-RELAY 21-POWER INLET 7 21A-Fuse(1ea) 18-POWER SWITCH 17-MAIN PLATE 16A-Bracket/Main Plate "T" screw(1ea) 16B-Bracket/Sensor thumbscrew(2ea) 16-PHOTOSENSOR BRACKET (For clear or reflective material, consult factory.
SET-UP INSTRUCTIONS ADJUSTMENTS Using 5/32" (4mm) hex wrench, adjust reel holder arm to vertical. Hold Down Brush: Place the label roll on the 1" (25mm) reel hanger bar. Using the upper thumbscrew on the side of the machine, adjust the hold down brush for tensioning. *If roll has 3" (76.2mm) core, use plastic spool* Slide “O” ring onto reel hanger bar to hold roll against reel holder arm to ensure it is held straight. For best results, labels should be pressed firmly against the strip plate.
FEATURES MAINTENANCE Turn machine off when not in use. Remove liner material from take-up hub at approximately 3" in diameter or if motor appears to be straining. Do not operate machine without covers in place. Do not operate if inspection reveals a damaged power or sensor cord.
