Quick Start Guide

Quick Start Guide
6
The printer has a RS-232 port (Figure 2, 1), a USB port (Figure 2, 2) and an
Ethernet port (Figure 2, 3).
Figure 2, Interfaces and Connectors
1. Plug the power cable into the power connection socket on the back of the
printer (Figure 2, 4).
2. Plug the power cable into a grounded 100 to 240 V ~ (50 to 60 Hz) power
source.
NOTE: The label printer senses the voltage type and automatically
adjusts for the power source.
3. Connect the printer to the computer using the supplied USB cable. The
USB cable connects to the printer at the port (Figure 2, 2) and to a USB
port on the computer.
4. If you do not have BradySoft, BradyCode, LabelMark or IdentiLab
software installed on your computer:
(a) Insert the BradySoft software CD in the CD reader on your computer.
(a) Follow the autoload directions for software installation.
5. Turn on the power switch on the back of the printer (Figure 2, 5). The
printer will perform a self test and then go into Ready mode.
1
2
3
4
5