Quick Start Guide

Quick Start Guide
13
The front display should read Ready and display the type of material loaded
into the printer as well as the type of ribbon loaded. Figure 9 is an example of
a typical display.
Figure 9, Typical Ready Display
If the printer is in a state other than Ready, refer to the “Brady IP™ Printer
Operator’s/Configuration Guide” located on the product CD to determine what
the problem might be.
Calibrating the Printer
No calibration is necessary when using BradySoft, BradyCode, IdentiLab or
LabelMark software and Brady non-metallized materials. For operation of the
printer with other manufacturer’s labels, metallized labels and other software
packages, refer to the “Brady IP™ Printer Operator’s/Configuration Manual”
located on the Product CD.
Printing
When the ribbon and material are installed and the printer is powered up and
connected to the computer, the printer is ready for use. Start the printing
program (BradySoft, LabelMark, or Identilab) and the program should identify
the labeling material installed in the printer. At this time, refer to the manual for
your selected software for the creation and printing of the labels.