Quick Start Guide

Quick Start Guide
10
Loading the Material
Figure 6, Material Supply Holder
1. Remove the material supply holder (Figure 6) from the printer by lifting it
up and out of the frame.
2. Press and hold the green tab (Figure 6, 1) on the material supply holder
and slide the end piece (Figure 6, 2) outward.
NOTICE
There are sensors located under the side tabs
(Figure 6, 3) on both sides of the material supply
holder. Be careful not to damage these sensors or
the label printer will be unable to read the material
identification tag on the labels.
3
2
1