Service manual

24 Service Manual Edition 12/07

Settings and Adjustments

Brady IP Series Printer

3.3 Adjusting the print mechanism

Major adjustment of the print mechanism beyond format-based settings is only required if the printhead

assembly has been removed or parts in this area have been replaced. Excluded from this is the replace-

ment of the printhead, after which readjustment is generally not required.

The following print quality imperfections may require a correction of the print mechanism adjustment:

− Print image too light

− Print image is spotty

− Print image lighter on one side

− Horizontal lines not parallel to the horizontal label edges

− Clear lateral drift of the transfer ribbon

3.3.1 Adjusting elements

Fig. 16: Printhead adjusting elements

NOTE!

Print image errors can also arise from wrinkling of the transfer ribbon. Check the transfer ribbon feed

path.

Printhead

2 Screws for horizontal alignment

3 Screws for adjusting the printhead pressure

4 Screw for adjusting the printhead bend

2 4 23 3