User guide

Advanced LabelMark Techniques 31
Advanced LabelMark Techniques
Modifying a Label Part
LabelMark contains an extensive list of master Brady parts. However, you may need to modify an existing
label part. The Label Part Setup feature allows you to do this by setting the label size, margins, etc.
Standard Sheet-Fed Part Layout
A – Top margin
B – Left margin
C – Horizontal gap
D – Vertical gap
E – Label width
F – Label height
G – Printable width
H – Printable height
Note: X- and Y-Offset are
zero.
To modify an existing label part’s settings:
1. Click Label Part Setup
on the Standard toolbar.
2. Click the Edit Part tab.
3. Make your desired modifications to the label settings:
 Restore – click Restore at any time to bring back the original settings and refresh the label
file if you applied the changes to the file.
 Labels per page – the number of labels on the page for a sheet or roll of labels.
Across
The number of labels across a sheet (left to right) or across
the width of a roll.
Down
The amount of rows per page.
For Dot Matrix, Thermal, and TLS2200/TLS PC Link
parts, this will generally be 1 to minimize label waste.
For Ink Jet and Laser parts, enter the amount that fits on
your page (8 1/2”x11” or A4).
 Margins – the absolute margin from the physical edge of the label liner to the label.
Left
The distance from the left edge of the liner to the left edge
of the label.
Top
The distance from top edge of the sheet liner to the top
edge of the label. Set Top to 0 for roll-fed parts, since it is
not applicable. Roll-fed parts use the horizontal and
vertical gaps for this purpose.