Operator`s manual

52
position that can become critical when using reflective or notched stock with a
small TOF mark. Three required readings are:
Empty: No media in the Media Sensor.
Mark or Gap: Only the backing (liner) material, notch, or reflective mark in the
sensor.
Paper: With an unmarked label area (a space without pre-printing) in the
sensor.
To perform a Standard Calibration:
Step Operator Action Displayed Message Comment
1
Turn ‘On’ the printer.
Wait until
‘Ready’ is
displayed.
2
Press the
key to enter
Menu Mode.
Lift the printhead for visual
access to the Media Sensor
and load label media.
See Section
4.0.2 for
details.
3 Press the key to
enter the Media Settings
menu.
See Section
4.1.1 for
details.
4 Press the key.
See Section
4.1.1 for
details.
5 Press the key. Use
the key to scroll
to the desired sensor type
and press the
key
to enable the selection.
See Section
4.1.1 for
details.
The enabled
selection will
be indicated
with an *
.
(Continued next page)