Operator`s manual

50
Lower the printhead and rotate the Printhead Latch back to the locked
position. Close the Access Cover.
If you are using die-cut media proceed to Step 6; otherwise, from READY
mode, enter the Media Settings menu and verify that the correct ‘Sensor
Type’ is selected for your media; see Section 4.1.1.
Exit the Media Settings menu and return to READY mode.
Press and hold the FEED key until 2-3 labels are advanced (approximately
4 seconds) to set the TOF; see Section 5.2. If ‘Uncalibrated’, ‘Top of Form
Fault’, or ‘Position Error, is displayed go to Section 5.3.
Note: Start-of-print distance changes can be made using the Print
Control/Row Adjust or Row Offset (see Section 4.1.2) or through
your software labeling program.