Operator`s manual

39
Communications (continued)
HOST TIMEOUT VALUE ♦
10 (1-60)
The number of seconds an active
communications port must be idle before
the printer may process data from a
different port. This value is also used to
“timeout” an image / label download.
CONTROL CODES ♦
Allows the operator to change the prefix of
the commands listed in the Programmer’s
Manual, as they are interpreted by the
printer.
STANDARD CODES
Hex 01 = SOH command; Hex 02 = STX
command
ALTERNATE CODES
Hex 5E = SOH command; Hex 7E = STX
command
FEEDBACK MODE
Returns a 0x30, [RS], after each label
successfully prints, and a 0x31, [US], after
each batch of labels in printed.
ENABLE
Feedback characters are sent.
DISABLE
No feedback characters are sent.