Operator`s manual

19
Route the media back to the Media Rewind Hub as shown below.
Insert the edge of the labels into the Slot on the Rewind Hub and then
insert the Media Retainer into the Slot.
Slide the Media Retainer over the media and onto a Slot on the Media
Rewind Hub and rotate the hub to remove any slack in the Media.
)
After loading, close the Access Cover and then press the FEED key to
secure the media.
Removal:
Grasp the printed labels on the Media Rewind Hub, and while gently pulling
out on the hub, compress the hub and pull off the labels.