Operator`s manual

3.3 Loading the Media Rewinder

With the Media Rewinder option, the printer can wind labels and backing

material. When equipped with the Peel and Present option, labels can be

separated automatically. The following subsections illustrate both set-ups:

3.3.1 Winding Labels

Note: When winding labels, the outer diameter of the wound stock cannot

exceed 6”.

Remove the Front Fascia.

Remove the Tear Plate by

first removing the

Thumbscrew.

Position the Rewind Plate

on the printer and install

and tighten the

Thumbscrew.

Remove the Media Retainer from the Media Rewind Hub.

With media loaded as described in Section 3.2, press the FEED key to

advance approximately 20 inches of media.

(Continued next page)