Operator`s manual

16
3.2.1 Roll Media
Media Hanger
equipped: place
Roll Media onto the
hanger as shown,
sliding it over
against the
Backstop; then
raise the Media
Retainer and slide it
over to rest firmly
against the roll.
Rotating Media Hub equipped: place Roll Media onto the hub, sliding it
over against the Backstop.
Route the media through the printer as shown below: under the Media
Idler, through the Media Sensor and out the front of the printer.
Raise and slide the Media Guide over to rest lightly against the media’s
edge.
Slide the Media Sensor into position; see Section 5.1 for details.
Lower the printhead and rotate the Printhead Latch back to the locked
position. Close the Access Cover.
)
If you are printing with thermal transfer media, see Section 3.4 for ribbon
loading instructions.
)
If you have a thermal transfer printer but will be printing on direct thermal
labels, see Section 4.1.1 for instructions to select direct thermal media in
the Media Settings menu.