Operator`s manual

104
Thermal Printhead
This warranty is limited to a period of one year, (365 days), or 1,000,000 linear
inches of use, whichever comes first, for the 2461, 3481 or 6441 thermal
printhead. This one year (365 days) warranty is valid only if a Brady - approved
thermal label media is used, as defined in the then current Brady list of
approved thermal/thermal transfer media, a copy of which is available from
Brady. Failure to use Brady-approved media is justification for invalidation of
this thermal printhead warranty. This warranty does not cover printheads which
have been misused, altered, neglected, handled carelessly, or damaged due to
improper cleaning or unauthorized repairs.
Warranty Service Procedures
If a defect should occur during the warranty period, the defective unit shall be
returned, freight and insurance prepaid, in the original shipping containers, to
Brady at: 6555 W. Good Hope Road, Milwaukee, Wisconsin, 53223. A Return
Material Authorization (RMA) number must be issued before the product can be
returned. To open an RMA please call the Brady Customer Service Department
at 1-800-537-8791. Please include your RMA number on the outside of the box
and on the shipping document. Include a contact name, action desired, a detailed
description of the problem(s), and examples when possible with the defective
unit. Brady shall not be responsible for any loss or damages incurred in
shipping. Any warranty work to be performed by Brady shall be subject to
Brady’s confirmation that such product meets Brady warranty. In the event of a
defect covered by its warranty, Brady will return the repaired or replaced
product to the Purchaser at Brady’s cost.
With respect to a defect in hardware covered by the warranty, the warranty shall
continue in effect until the end of the original warranty period, or for sixty (60)
days after the repair or replacement, whichever is later.