Specification

area with foam. Remove with vacuum trucks or pump to storage/salvage vessels. Soak up

residue with an absorbent such as clay, sand or other suitable material and dispose of properly.

Flush area with water to remove trace residue. Contain run-off from residue flush and dispose

of properly. Prevent entry into waterways, sewer, basements or confined areas. For small spills:

Soak up residue with an absorbent such as clay, sand or other suitable material. Place in non-

leaking container and seal tightly for proper disposal.

Disposal:

Proper disposal should be evaluated based on regulatory status of this material (refer to section

13), potential contamination from subsequent use and spillage, and regulations governing

disposal in the local area.

Reporting:

Notify authorities if any exposures to the general public or environment occurs or is likely to

occur.

SECTION VII – Handling and Storage

Do not taste or swallow. Avoid contact with eyes, skin and clothing. Wash thoroughly after

handling.

Handling:

Surfaces that are sufficiently hot may ignite liquid material. Vapors are flammable and heavier

than air. Vapors may travel across the ground and reach remote ignition sources causing a

flashback fire danger. Do not store or handle in aluminum equipment at temperatures above

120° F (48.9° C).

Keep away from heat, sparks and flame. Extinguish pilot lights, cigarettes and turn off other

sources of ignition prior to use and until all vapors have dissipated. Use explosion-proof

ventilation to prevent vapor accumulation while in use. Properly dispose of any contaminated

rags or cleaning materials in order to prevent fires. Air-dry contaminated clothing in a well-

ventilated area before laundering. Static electricity may accumulate and create a fire hazard.

Bond and ground handling equipment and transfer containers to prevent sparking.

Storage:

Keep containers closed when not in use.

Ground fixed equipment.

Container Warnings:

Containers, even those that have been emptied, can contain explosive vapors. Do not cut, drill,

grind, weld or perform similar operations on or near containers.

SECTION VIII - Exposure Controls/Personal Protection

Material Source TWA STEL

Isopropyl Alcohol ACGIH –TLV 400 ppm (v) 500 ppm (v)

Isopropyl Alcohol OSHA –PEL 400 ppm (v) 500 ppm (v)

Isopropyl Alcohol OSHA -PEL-InterimStandard 400 ppm (v)