User Manual

BMP
®
61 User’s Manual 26
Introduction
Setup
Setup
The Setup function is used to determine the default settings for the printer. Under this function are the
following features:
• Pause/Cut
• Config (Printer Configuration)
• Time/Date
• Units
• Language
• Font Settings
• Print History
• Touch Screen Calibration
To access Setup functions, simultaneously press the Function (FN) and Setup keys.
Pause/Cut
The Pause/Cut function allows you to set whether the printer pauses to cut at the end of the print job or
after a single label is printed. When the feature is turned on, printing is paused after each label. When
the feature is turned off, printing pauses at the end of the job.
To turn the Pause/Cut function ON/OFF, press the Function and Setup keys.
Config (Printer Configuration)
• Shut Off Delay sets the auto-off time-out. This is the number of minutes of inactivity after which the
printer automatically shuts off.
When using the AC adapter, power is constant so there is no drain on the battery. In this case,
you can turn off the Shut Off Delay by choosing No Shut off (AC).
• Brightness setting increases or decreases the brightness of the display screen.
•The Clean Printer button is used in conjunction with the electronic cleaning card, which can be
purchased separately. (See “Internal Components” on page 83 of this manual for instructions
on how to clean the printer.)
•The Firmware version currently installed can be found in the lower left corner of the screen.
•
Y and B version currently installed is shown on the right side of the screen.
Time/Date
To access the time/date dialog box, press the Function and Setup keys. Set the date and
time, as well as the format in which you want them to display.