User Manual

Terminal Block, Patch Panel (BMP®21-PLUS and 2.0 or higher)

Selecting a Label Type

BMP

21-PLUS/BMP

21-LAB User Manual

Terminal Block, Patch Panel

(BMP

21-PLUS and 2.0 or higher)

Terminal Block and Patch Panel label types are designed to be used with any media, except

SelfLam or Permasleeve. If SelfLam or Permasleeve is installed, these label types are not

available.

To use Terminal Block or Patch Panel:

1. Press LABEL TYPE .

2. Navigate to the desired label type and press Enter .

Data fields display requesting additional information. (For a review of data field navigation,

see page 24.) The data fields for Terminal Block and Patch Panel are similar.

1. In the Spacing: field, choose a pre-programmed value using the left or right navigation

key or, when the cursor is flashing, enter your own value* for the amount of space that

exists between the terminals or ports.

*If a custom value was previously entered, it will remain in the printer.

Note: If you have indicated the correct spacing between the requested number of

terminals or ports, the printed label can be attached to the terminal block or patch

panel as one strip. There is no need to cut and adhere each individual block or port

identifier.

2. Navigate to the Serial: field, then use the left or right navigation key to turn serialization

ON or OFF.

If serialization is turned ON, proceed to Step 4.

Note: If serialization is turned ON, you do not have to specify the number of

terminations (or the number of ports if using Patch Panel).

Terminal Block data fields Patch Panel data fields