User guide

43
4. Entering and Editing Text/Symbols
If the “A–Z” option is entered, set the “Start” alphabet (default
is A), the “End” alphabet (default is B) and the “Increment By”
number (default is 1) and then press [OK].
If the Paddings option is entered, select “Space”, “0” or
“None” to set “Padding character” and then press [OK].
The Serialization Continuous Print menu appears.
The only valid characters that can be used in padding are
zero (“0”) or a blank space (“ ”). before the line “The
Serialization Continuous Print menu appears.”
3. In the Serialization Continuous Print menu, set the number of
copies (1-999) to be printed and press [OK].
The increment step must always be >= 1.
I. Adding a Barcode to a Tag
Barcodes can be added to 9 mm and 12 mm labels only
(and not on any tubes) on the printer. Depending on the
type selected, the valid data range may vary.
The segment has to be auto-sized or >25 mm if fixed size.
Only upper-case characters and digits 0-9 are allowed for
code 39.
1. Enter [Menu] > “Barcode”.
The Barcode menu appears, with “Set Barcode” highlighted.
2. Press [OK]. The options (“Type” and “HR Text”) in the Set
Barcode menu appears, with “Type” highlighted.
3. Press [OK]. The Type submenu options appear, with
“Code39” highlighted.
4. In the Type list, select your preferred type (“Code 128” or
“Code 39”) and press [OK].
5. In the HR Text list, select “On” (or “Off”) and press [OK].
6. Press [Menu Return] twice. The Set Barcode options disappear.
7. Select “Barcode Data” and press [OK].
8. Enter the desired text and press [OK] to confirm.
9. Press [Close] to return to the Tag Editor.
OK
OK
When “Padding character” is off
When “Padding character” is on
• When inserting zeroes
Insert “0”
Insert space
• When inserting spaces
Port 1 Port 2 Port 3 Port 4
Port 1 Port 2 Port 3 Port 4
Port 01 Port 02 Port 03 Port 04
OK
Menu
OK
OK
OK
OK
OK
OK
BMP91UG.book Page 43 Friday, October 14, 2011 7:56 PM