User`s manual

Setup
Setup Printer Configuration
32
BMP71 User’s Manual
To clean the printer:
1. Choose Config and press OK or Enter .
2. Navigate to the Clean Printer button and press OK or Enter
.
3. Follow the instructions on the screen.
4. Place the cleaning card in the label compartment of the printer, inserting the left edge of
the card up to the black line under the ribs.
5. Close the printer cover, ensuring that it latches.
6. Press OK key to initiate the clearning routine.
NoteNote
Allow 15 seconds for the print head, platen roller, and label path to dry before
reloading labels and the ribbon cartridge.
Cleaning the Cutter Blade and Sensors
The stationary and movable cutter blade should be cleaned periodically to remove any
adhesive buildup from cut labels. Likewise, the sensors inside the printer compartment should
also be cleaned on a regular basis to ensure accurate readings. You should also clean any other
area in the print compartment that may accumulate dust.
To clean the cutter blade:
1. From the cleaning kit, remove the premoistened cotton swab from its wrapper.
WARNINGWARNINGWARNING
The cutter blade is cleaned from OUTSIDE the printer. To avoid injury, never clean the
blade from inside the print compartment.
2. With the print cover closed, pull up slightly on the cutter lever to expose the blade.
3. Entering from the label output tray, insert the swab and gently wipe the cutting edge of the
movable cutter blade.