User`s manual

BBP

33 Sign & Label Printer

User’s Manual

2-7

Unpack and Set up Printer

Set up the Printer

3. If engaged, swing yellow media wiper [3] to the back.

4. Slide yellow media guides [4] to full-open.

5. Remove existing media, if installed, by pulling cartridge from printer.

6. Insert media cartridge until spindle ends rest in slots of media holder [6].

Media unwinds from the top of the roll and the smart cell should be on the left

side of the spindle.

7. Feed media from top of roll until it sits just past the black rubber roller.

8. Close media guides until they touch edge of media liner with media under the

guides.

9. Move media wiper into position so it rests on media.

Note: Not all media requires the use of the media wiper. Engage the media

wiper only if continuous media is installed.

10. Close and latch ribbon cover.

11. Close the enclosure cover.

12. If printer was off, press . The system detects the installed supplies and

indicates the amount of remaining supplies on the display screen.