Datasheet
● Service Temperature: -20° to 120°C
(-0° to 250°F)
Chemical Resistance
All approved chemicals listed are based on the
manufacturer's specified chemical resistance chart for plastic
material only.
Dimensions
"A”
-
1.26" [32mm]
"B"
-
1.38" [35mm]
"C"
-
0.63" [16mm]
"D"
-
4.25" [108mm]
8.50" [216mm]
"⍉0 E"
-
⍉0.19" [4.74]
Details :
MSDS Information
1. HAZARDS IDENTIFICATION
This product is NOT DANGEROUS and contains no hazardous ingredients.
2. FIRST AID MEASURES/HEALTH INFORMATION /PROTECTION
Eye Contact:
Not applicable, product is inert
Ingestion:
Not applicable, first aid is not normally required.
Inhalation:
Not applicable
Skin Contact:
Not applicable, product is inert, except if product is melted use gloves. For hot melted product, immerse in or flush affected area with water to
dissipate heat, then obtain medical attention.
Exposure Limits:
None
Threshold Limits
None
Personal Protection:
None (ambient conditions)
NPCA-HMIS Rating:
Health: 0; Flammability: 1; Reactivity: 0
NFPA-704 Rating:
Health: 0; Flammability: 1; Reactivity: 0
3. FIRE-FIGHTING MEASURES
• Be cautious of hot melted Nylon
• Use water spray to cool fire, exposed surfaces, and to protect personnel
• Isolate product from fire
• Respiratory and eye protection is required for fire fighting personnel
• Extinguish fire with water spray
• Decomposition products under fire conditions: Oxygen-lean conditions may cause
monoxide and irritating smoke
4. ACCIDENTAL RELEASE MEASURES
Land
Recover material and place in suitable container for reuse or for disposal in conformance with local regulations.
Water
Recover material and place in suitable container for reuse or for disposal in conformance with local regulations.
5.
HANDLING AND STORAGE
5.1 Handling
5.2 Storage
No precautions noted-see local regulation if needed
Storage pressure: Atmospheric
Storage temperature: Ambient, no direct sunlight
6. EXPOSURE CONTROL/PERSONAL PROTECTION
6.1 Exposure limit values
6.2 Exposure Controls




