Troubleshooting guide

Bradley Washfountains Parts and Service Guide
44 Bradley Corporation • 215-1370 Rev. M; EN 08-003
1/7/08
NOTE: Flush supply lines before making connections.
Follow the procedures below and refer to Figures below when installing tubing to ensure that
you achieve a leakproof seal.
• Using a sharp razor, cut tubing squarely and remove any burrs. DO NOT pinch or crush end
of tubing.
• Loosen nut on fitting. Moisten end of tube and push into fitting until it is firmly seated.
Tighten nut to secure tube to fitting (make sure nut is securely tightened).
• If connector leaks, reseat tubing according to above procedure. If leaking persists,
replace male connector, or call your Bradley representative for assistance.
SPRAYHEAD
TUBING
NUT
MALE
TUBE
CONNECTOR
269-626
TUBING
Sprayhead Tubing Connections