Installation manual

Terreon® Deep Bowl 36" Semi-Circular Washfountain with TouchTime
+
Control
Installation Instructions TDB3103, WF3203
Bradley Corporation • 215-1579 Rev. C; EN 06-915
72/12/07
Installation Instructions
Step 1: Rough-In Drain & Supplies
1. Rough in supply and drain piping as required for your installation (see pages 5-6 for rough-ins of
optional installations).
Step 2: Bowl/pedestal mounting and assembly
1. Attach the stainless steel pedestal base to the pedestal using supplied screws and finishing wash-
ers. For wall-mounted models, see Pages 3-4 for pedestal height.
2. Position the pedestal at the desired location and mark the position of the (4) pedestal wall mount-
ing locations.
3. Secure the pedestal to the wall with suitable fasteners, 1/2" anchors and 1/2" bolts (supplied by
installer) (see Figure 1b for wall mounting locations).
4. Using two people, carefully lift the bowl onto the pedestal (see Figure 4).
5. Position the bowl so that the threaded rods in the bowl mate with the slotted holes in the
pedestal (see Figure 4).
NOTE: Before attaching 1/4" wing nuts and washers to threaded rods, remove red protective caps
from threaded rods. Discard sleeve caps after removal.
6. Using 1/4" wing nuts and washers, secure the bowl to the pedestal, three places (see Figure 4).
CAUTION: BOWL SURFACE IS SMOOTH. APPROXIMATE WEIGHT OF BOWL IS 75
POUNDS. HANDLE WITH CARE!
Figure 4