Specifications

Installation TDB3104, WF3204
Bradley • 215-1479 Rev. J; EN 12-00-004 1/10/2013 7
1
Rough-in Drain and Supplies
A
Rough in supply and drain piping
as required for your installation.
CAUTION! Bowl surface is very smooth. Approximate
weight of bowl is 75 pounds. Handle with Care!
2
Bowl/Pedestal Mounting and Assembly
A
Attach the stainless steel pedestal base
to the pedestal using supplied screws and
finishing washers.
C
Secure pedestal to wall with suitable
fasteners, 1/2" anchors and 1/2" bolts
(supplied by installer).
D
Using two people, carefully lift bowl onto
pedestal.
E
Position the bowl so that the threaded rods
in the bowl mate with the slotted holes in
the pedestal.
F
Using 1/4" wing nuts and washers, secure
the bowl to the pedestal, three places.
Top View
Drain
Position the pedestal at the desired location
and mark the position of the (4) pedestal
wall mounting locations.
B
Front View
Place Hands
Here When
Lifting Bowl
Threaded Rod
(Secured by 1/4"
wing nut and
washer)
Pedestal
(219-039)
Base Assembly, Standard Height
(S17-281)
Base Assembly, TAS (S17-284)
Base Assembly, Juvenile Height
(S17-285)
Shell, Wall Mounted - Trim Piece
(186-1306)
Wall Mounting
Locations
(Typical)
Place Hands
Here When
Lifting Bowl
Drain
#10 - 24 Screw (3)
(160-248)
Finish Washers (3)
(142-002CA)
Before attaching 1/4" wing nuts and washer to
threaded rod, remove red protective caps from
threaded rods. Discard sleeve caps after removal.