Specifications

TDB3104, WF3204 Installation
2 1/10/2013 Bradley • 215-1479 Rev. J; EN 12-00-004
IMPORTANT!
Read this entire installation manual to ensure proper installation. When finished with the
installation, file this manual with the owner or maintenance department.
Separate parts from packaging and make sure all parts are accounted for before discarding
any packaging material. If any parts are missing, do not begin installation until you obtain
the missing parts.
Make sure that all water supply lines have been flushed and then completely turned off
before beginning installation. Debris in supply lines can cause valves to malfunction.
Hardware supplied by installer must be appropriate for wall construction. Wall anchors used
must have a minimum pull-out rating of 1,000 lbs.
Product warranties may be found under “Product” on our web site
at www.bradleycorp.com.
Installation
THIS
SIDE
UP
Packing List
•
•
•
•
Supplies Required by Installer
• (4) 1/2" lag bolts, screws or other fasteners to anchor washfountain pedestal
• 1/2" nominal copper tubing for hot and cold water supply lines.
• Standard P-trap
• 1-1/2" drain lines and fittings
• Teflon tape or pipe dope
Pre-Installation Information
Terreon Material
The Washfountain is constructed of Terreon
®
, a densified solid surface material composed of polyester resin. Terreon is resistant to
chemicals, stains, burns and impact. Surface damage can be easily repaired with everyday cleaners or fine-grit abrasives. Terreon
is NAHB certified to meet ANSI Z124.3, Z124.6 and ANSI/ICPA SS-1-2001.
Air Metering Valve
The sprayhead is controlled by a pushbutton cylindrical air valve, allowing the user to activate a flow of water.