Specifications

TDB3104, WF3204 Installation
16 1/10/2013 Bradley • 215-1479 Rev. J; EN 12-00-004
Actuator Module Components
* Included in Actuator Assembly (S65-168)
Metering Air Valve Maintenance
Adjust Air Valve Meter Time
Duckbill Check* (198-010)
Piston* (119-227A)
U-Cup* (125-099)
Spring* (135-065)
Screw (160-165)
Actuator Body* (118-279)
Straight Tube Connector* (169-890)
Nut (110-115)
Acutator Bracket (140-743)
Pushbutton Assembly (S08-324)
A
Remove filter cap and use a screwdriver to
tighten or loosen the timer. Turning the timer
clockwise increases the time; turning the
timer counterclockwise decreases the time.
The air valve timer is located next to the tube connector on the air valve body. The timeer is capped
with a filter to prevent build-up on the timer. The air valve timing can be adjusted from 5 to 60 seconds.
B
Continue to adjust until the timer is set at
desired length.
C
Replace filter cap over the timer.
Water Tube Connector
Air Valve
Filter Cap
Air Tube Connector
Adjust Air Valve Meter Time
A
Push in the white manual release button
while pulling the tube out to disconnect the
tube at the connector. No tools are needed.
B
To correct a leak, press tubing firmly into the
connector and make sure it is seated.
C
If leak persists, remove tubing from the fitting
and trim the tubing end square with a razor-
sharp knife. If leak continutes, replace the
fitting or contact your Bradley representative
for assistance.
Air Valve Tubing
Manual Release
Button
Sealing Ring
Tube Stop
Gripping Ridge
Locking Slope