Specifications

ManualsBrandsBradley ManualsHome building and DecorTerreon WF3204

P.O. Box 309, Menomonee Falls, WI USA 53052-0309

PHONE 800.BRADLEY (800.272.3539) FAX 262.251.5817

bradleycorp.com

Installation

TDB3103

Terreon

36" Semi-circular Deep Bowl

Washfountain with Air Metering Control

WF3203

Terreon Extra Height 36" Semi-Circular

Classic Washfountain with 9" Deep Bowl

and Air Metering Control

215-1479 Rev. J; EN 12-00-004

Page 1 of 18 1/10/2013

TDB3103

WF3203

Table of Contents

Supplies Required by Installer......................2

Pre-Installation Information ........................2

Semi-Circular Washfountain Dimensions ........... 3-4

Rough-In Specifications......................... 5-6

Rough-In Drain and Supplies ......................7

Bowl/Pedestal Mounting and Assembly ..............7

Installing Drain Spud in Bowl.......................8

Connect Supply Stops, Sprayhead Supply Tubing,

and P-Trap .....................................8

Sprayhead, Actuator Module, and Thermostatic

Mixing Valve Installation ..........................9

Adjust the Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Cleaning and Maintenance .................... 11-12

Soap Valve Parts List and Maintenance .......... 13-14

Sprayhead Parts List and Troubleshooting ...........15

Actuator Module Components.....................16

Metering Air Valve Troubleshooting .................17

Thermostatic Mixing Valve Troubleshooting...........18

Summary of content (18 pages)

PAGE 1
Installation TDB3103 Terreon 36" Semi-circular Deep Bowl Washfountain with Air Metering Control ® WF3203 TDB3103 Terreon Extra Height 36" Semi-Circular Classic Washfountain with 9" Deep Bowl and Air Metering Control Table of Contents WF3203 215-1479 Rev. J; EN 12-00-004 © 2013 Bradley Page 1 of 18 1/10/2013 Supplies Required by Installer . . . . . . . . . . . . . . . . . . . . . 2 Pre-Installation Information . . . . . . . . . . . . . . . . . . . . . . . . 2 Semi-Circular Washfountain Dimensions .
PAGE 2
TDB3104, WF3204 Installation IMPORTANT! Read this entire installation manual to ensure proper installation. When finished with the installation, file this manual with the owner or maintenance department. Installation Packing List IS TH SIDE UP • • • • Separate parts from packaging and make sure all parts are accounted for before discarding any packaging material. If any parts are missing, do not begin installation until you obtain the missing parts.
PAGE 3
TDB3104, WF3204 Installation Semi-Circular Washfountain Dimensions 22-3/4" (577) Model TDB3103 36" Semi-circular - side view Top View 14-1/16" (357) 4-3/4" (121) 13-1/2" (343) 36" (914) 6" (152) *53-1/4" (1353) Back View *44-7/8" (1140) 14" (356) 8" (203) *41-1/4" (1048) *34" (864) *38" (965) *24-1/2" (622) *30-3/8" (772) Optional equipment may not comply with all ADA dimensional guidelines 14" (356) 12" (305) *9" (229) *10" (254) 5-1/2" (140) 7" (178) Bottom View 10" (254) 5-1/2" (1
PAGE 4
TDB3104, WF3204 Installation Semi-Circular Washfountain Dimensions Model WF3203 Top View 36" Semi-circular - side view 6" (152) 22-3/4" (577) 13-3/8" (340) 4-5/8" (118) 36" (914) 52-11/16" (1339) Back View 44-1/2" (1131) 14" (356) 8" (203) 41-1/8" (1046) 39" (991) 35" (889) 24-1/2" (622) 5-1/2" (140) 14" (356) 12" (305) 9" (229) 10" (254) 7" (178) Bottom View 10" (254) 5-1/2" (140) 4 1/10/2013 Bradley • 215-1479 Rev.
PAGE 5
TDB3104, WF3204 Installation (mm) Semi-Circular Washfountian Rough-Ins 1" (25) 1-1/2" NPT Drain from the Wall Pedestal Opening at Wall 9" (229) Hot 1/2" Nominal Copper Tubing for Supply Lines, Stub Out 1" from Wall Cold 34" (864) Rim Height* See Table Below 12" (305)* See Table Below 2" (51) 4" (102) Finished Floor *Adjustments to Vertical Dimensions for Various Rim Heights Rim Height Application Adjustment 34" 35" (WF3203) Adult Height ADA, TAS Adult Height None, as shown 32" TAS Ages 11
PAGE 6
TDB3104, WF3204 Installation Rough-In Specifications Type A Drain 1/2" Nominal Copper Tubing for Cold Supply, Through Wall 1" (25) - Supplies through wall - Vented through wall off-drain (mm) Drain P-Trap and supplies by others. 1-1/2" NPT Drain 2" (51) 36" Bowl (914) 2" (51) 4" (102) 5" R.
PAGE 7
TDB3104, WF3204 Installation 1 A 2 A B Rough-in Drain and Supplies Rough in supply and drain piping as required for your installation. Bowl/Pedestal Mounting and Assembly Before attaching 1/4" wing nuts and washer to threaded rod, remove red protective caps from threaded rods. Discard sleeve caps after removal. Attach the stainless steel pedestal base to the pedestal using supplied screws and finishing washers.
PAGE 8
TDB3104, WF3204 3 A Installation Installing Drain Spud in Bowl Secure drain spud with lock nut and washers. Seal between drain spud and drain hole with plumber’s putty (supplied by installer). Bowl Strainer and Spud Drain Pre-Pack (S45-273) Apply Plumber's Putty Here Fiber Washer Locknut 4 8 Connect Supply Stops, Sprayhead Supply Tubing, and P-Trap A Connect supply stops onto stub-outs. B Using a sharp knife, cut tubing squarely and remove any burrs. Do not pinch or crush end of tubing.
PAGE 9
TDB3104, WF3204 Installation 5 Sprayhead, Actuator Module, and Thermostatic Mixing Valve Installation A Install hemmed end (not sharp end) of support tube with gasket onto bowl. B Place sprayhead with 3/8" tubing onto support tube. Run the tubing down through the support tube. Make sure the spray holes point away from the wall. C D Skip to step F for units without soap. Place the upper tie bar (notched at both corners of each end) on top of sprayhead parallel to wall.
PAGE 10
TDB3104, WF3204 Installation Unit with "O" Drain and Actuator Module Shown, Also Available with "A" Drain Valve and Tubing Connections Air metering Valve Top Cover Restraining Bracket (140-128) Tie Rod (176-008A) To Fitting (145-105) 3/8" Tubing (R68-600014) Soap Dispenser Tie Rod Nut (110-064) 8-5/8" Tie Rod Coupling Nut and Set Screw Spacer Module Cover 1/8" Air Tubing to Module (R68-600008) 4-1/4" Tie Rod (176-118) Coupling Nut and Set Screw Actuator Module Assembly 21-5/8" Tie Rod (176-0
PAGE 11
TDB3104, WF3204 Installation Cleaning and maintenance instructions for Terreon ® Material Description: Terreon is an NAHB Certified densified solid surface material composed of polyester resin and is resistant to chemicals, stains, burns and impact. Surface damage can be easily repaired with everyday cleansers or fine grit abrasives. ® Routine Cleaning: Clean daily or as often as conditions require using a standard commercial or household cleaner such as Formula 409 or Windex .
PAGE 12
TDB3104, WF3204 Installation Cleaning and maintenance instructions for stainless steel Material Description: Stainless steel is extremely durable, and maintenance is simple and inexpensive. Proper care, particularly under corrosive conditions, is essential. Always start with the simplest solution and work your way toward the more complicated. Routine cleaning: Daily or as often as needed use a solution of warm water and soap, detergent, or ammonia.
PAGE 13
TDB3104, WF3204 Installation Soap Valve — Liquid — S09-007S Parts List Attaching Parts S09-007S Item Part No. Description 1 118-025 Valve Body 1 2 110-007 Packing Nut 1 3 135-001L Spring 1 4 125-001BU Washer 1 5 119-028 Plunger 1 * 161-014 Nut 1 * 124-001D Washer 2 * 142-002AH Washer - Stainless Steel 1 3 1 Qty 4 5 2 * Not Illustrated This valve delivers a measured amount of soap with each upward stroke.
PAGE 14
TDB3104, WF3204 Installation Soap Valve — Powdered — S09-010A Parts List Item Part No. Qty 1 160-069 1 Screw, 1/4-20 RD 2 142-002X 1 Washer, 1/4 Split-Lock 3 S62-002 1 Agitator / Slide Assy. 4 192-004 1 Lever - Powdered Soap 1 2 Description 3 4 Reducer plugs are available for use with fine granulated soap to reduce the flow. Valves can be changed from powdered to liquid by plugging the innermost, or “bearing” hole with rubber plug, part number 125-001AK.
PAGE 15
TDB3104, WF3204 Installation Sprayheads — Standard w/Neoprene Spray Ring Grommet Repair kit does not include sprayhead grommet. Order as a separate item. 1 4 3 2 5 9 7 10 6 8 Parts List Sprayhead Assembly S05-054B Item Part No.
PAGE 16
TDB3104, WF3204 Installation Actuator Module Components U-Cup* (125-099) Piston* (119-227A) Duckbill Check* (198-010) Spring* (135-065) Screw (160-165) Actuator Body* (118-279) Pushbutton Assembly (S08-324) Straight Tube Connector* (169-890) Nut (110-115) Acutator Bracket (140-743) * Included in Actuator Assembly (S65-168) Metering Air Valve Maintenance Adjust Air Valve Meter Time The air valve timer is located next to the tube connector on the air valve body.
PAGE 17
TDB3104, WF3204 Installation Troubleshooting – Metering Air Valve 8 Turn off water supplies to the unit before troubleshooting. 7 5 Item Qty.
PAGE 18
TDB3104, WF3204 Installation Thermostatic Mixing Valve Troubleshooting Before attempting to troubleshoot the valve or disassemble the components, check for the following conditions: • If stop valves are used, make sure that they are fully open. • Make sure that the hot and cold inlet pipes are connected properly, and that there are no cross-connections or leaking stop valves. • Check the hot water heater output to make sure that it is at least 10° F above the set temperature.